06 Rhino 660 carb float adjustment
I have taken the carb off to rebuild and find the instructions in the manual confusing from what I am seeing looking at the carb float. The service manual says to adjust the float height to 13mm from the front mating surface to the top of the float. The picture shows the float to be somewhat level all the way across but mine is dipped down toward the end opposite the float attachment pen when held upside down. The note states the float arm should be resting on the needle valve but not compressing it but I can't see it good enough to tell what is going on as far as resting but not compressing. The carb started leaking fuel out of the carb so I am rebuilding it which consisted of replacing the float needle vale assembly which I suspect will take some adjustment if I can figure it out.