660 Engine, Cases, Ported Big Valve Head 105 Cylinder Ect
What I have is a complete disassembled big bore engine minus a crankshaft and cam.
Brand New Cases with Bearings.
All OEM Gaskets.
CNC Ported Cylinder Head and FERREA 1mm Oversize Stainless Valves by Racers Edge.
KIBBLE WHITE Valve Springs.
105mm Bore O'ring Cylinder with Copper Head Gasket by Racers Edge.
Mikuni HSR 48mm Carb w/ Throttle Cable.
Cycle Worx Intake w/ K&N Filter.
KMS Siphon Break
PDM Billet Center Diff Support.
Racers Edge Billet Cam Weight Pins.
CP Piston 10.0:1 NEW
CP Piston 11.5:1 (used)
PDM Billet Clutch Setup (NO Clutch) see pic.
All internals (gears, shafts, ect) are inspected and ready to go. Lots of new OEM parts, seals, gaskets, bearings, timing chain, ect.
This consist of a 07 660, low miles (347), complete engine that was built as a 797 (+8mm stroke crank) then the cases cracked. Engine was torn down, all internals inspected, all new cases, gaskets, bearings, ect were purchased for rebuild and then decided to go a different direction. Crank and cam have been sold. You can build what ever combination engine you want depending on what crank you go with. 727, 760, 797 ect. I can 99.9% guarantee all parts, nuts and bolts are there and some. Guarantee no major parts are missing. Would make right with buyer if something were missing.
May sell parts separate.
Look at pics. Text is better and faster.