Wide F'n Open
Join Date: Jun 2008
Location: Glennville Ca
Posts: 3,091
|
|
LinkBack | Thread Tools | Display Modes |
Fabtech spindle ?'s
Is it normal for the lower balljoint to fit loosely in a fabtech spindle? they have to be pressed in on the stockers, why not the fabtechs?
Pro-One GlasslHRT 2-seaterlPRP 4-point harnesslPRP High BackslDRD dualslDRD fuel management
Machined sheavelDynateck ECUlXMF +6l2-4" 3-7" HID's
| Sponsored Links | |||
|
Advertisement
|
|
||
3/4 Throttle
Join Date: Dec 2008
Posts: 56
Sounds like you have the ones for their LT kit which uses a uniball instead. Although they use top and bottom uniballs so if your top ball joint fits then there must be an issue. Contact Fabtech and give them the part number to see which ones you have.
Wide F'n Open
Join Date: Jun 2008
Location: Glennville Ca
Posts: 3,091
Quote:
Originally Posted by Socal
View Post
Sounds like you have the ones for their LT kit which uses a uniball instead. Although they use top and bottom uniballs so if your top ball joint fits then there must be an issue. Contact Fabtech and give them the part number to see which ones you have.
I knew they where their LT spindles, but i wasnt informed that they use lower uniballs.
Anyone want to buy some spindles for cheap?
Pro-One GlasslHRT 2-seaterlPRP 4-point harnesslPRP High BackslDRD dualslDRD fuel management
Machined sheavelDynateck ECUlXMF +6l2-4" 3-7" HID's
|
|
|
Wreckin' Shop
Join Date: Jun 2008
Location: B-Town foooooo
Posts: 5,385
Quote:
Originally Posted by mopar_enthusiast
View Post
Your right...
I knew they where their LT spindles, but i wasnt informed that they use lower uniballs.
Anyone want to buy some spindles for cheap?
I knew they where their LT spindles, but i wasnt informed that they use lower uniballs.
Anyone want to buy some spindles for cheap?
100% free webcam site! | Awesome chicks and it is absolutely free! | Watch free live sex cam - easy as 1-2-3
Wide F'n Open
Join Date: Jun 2008
Location: Glennville Ca
Posts: 3,091
Quote:
Originally Posted by BiggJim
View Post
The uni ball would be on the a-arm.....and would have a smaller 1/2 or 9/16 hole on bottom of the spindle. The spindles you have take a ball joint on bottom. Did you try install NEW ball joints? or are the Balls that have been pressed in and out before?
Pro-One GlasslHRT 2-seaterlPRP 4-point harnesslPRP High BackslDRD dualslDRD fuel management
Machined sheavelDynateck ECUlXMF +6l2-4" 3-7" HID's
| Sponsored Links | |
|
Advertisement
|
|
| Bookmarks |
| Thread Tools | |
|
Show Printable Version Show Printable Version
Email this Page Email this Page
|
|
| Display Modes | |
|
|
| Posting Rules | |
