Yamaha Rhino Forums - RhinoTalk banner
1 - 5 of 5 Posts

·
Registered
Joined
·
2,988 Posts
:mad:
the fan on the radiator stopped, it is freed up and will run when hooked to a power source. but it doesnt run when it is suppose to. this tells me the fan is ok but a relay/fuse is bad. anyone have this problem, idea to fix are appreciated.
check the fuses in the battery box, also there is 2 wires that go to a gel pack in there, that is the temp relay thingy, not sure if they go bad, but you can clip the wires and wire them together and see if the fan works to eliminate it as the problem.
 

·
Registered
Joined
·
3,155 Posts
check the switch/sender on the radiator also. you can take it out and put in hot water and see if it makes contact with an OHM meter.

Rog
 

·
Registered
Joined
·
53 Posts
i had same problm on my trex. start the motor take wires off temp sending unit put a jumpr wire between them. if fan comes on probly bad temp sensor if fan doesnt come on check fuses and mayb a fan reset.
 
1 - 5 of 5 Posts
Top