Yamaha Rhino Forums - RhinoTalk banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hello gang. New to the forum. I recently picked up a new to me 05 660 that's a recovery unit that had been crashed. I fixed the bent frame and got her running but whoever had it before me cut the plug off that goes into the back of the ignition switch. I bought a new switch and solenoid by I don't know what wire goes where on the back of the key switch due to the plug being gone. I've dug around on the net and can't find a pick of the plug/wires where I can determine this. I don't want to just trial and error it out of fear of causing some other electrical issue.

Can someone please pose a pic of their switch plug to give me an idea of where to start? Much thanks!

On another note, recs for a CDI upgrade would also be appreciated. I'm looking for just a little more power and no rev limiter, but nothing outlandish. Thanks again.
 
1 - 3 of 3 Posts
Top